Piezography Workshops at Cone Editions Press!
Page 2 of 2 FirstFirst 12
Results 11 to 17 of 17

Thread: K7 inksets and the new Ultra HD Matte Black Ink

  1. #11

  2. #12
    Junior Member
    Join Date
    Jul 2016
    Location
    Massachusetts USA
    Posts
    21
    My bottle of Utra HD Matte Black arrived, along with a new cartridge. I have downloaded the Community Edition software.

    After moving the chip to the new cartridge and filling it with the new HD ink, how can I flush the old ink - in a way that spends the least amount of the other inks ?

    Thank you !!

  3. #13
    Junior Member
    Join Date
    Jul 2016
    Location
    Massachusetts USA
    Posts
    21
    I do have a question:

    How can I flush the old ink - in a way that spends the least amount of the other inks ?

    Thank you !!

  4. #14
    Use the images and documentation from this page: http://www.inkjetmall.com/tech/conte...libration-Mode

    best,
    Walker

  5. #15
    Junior Member
    Join Date
    Jul 2016
    Location
    Massachusetts USA
    Posts
    21
    I was able to flush the old ink and I have installed the Community Edition. I have not re-installed the printer or PrintTool, from within the Community Edition.

    At this point I am only interested in making Matte prints with 7 inks on cotton rag paper.

    I will likely have you make profiles for me, rather than use any linearization tools, since I use only a few papers and appreciate how well you make them

    In order to print a target for you, I need to use a profile which is close. Where can I find profiles which approximate what I need, for K7 inks and Ultra HD Matte Black ? My primary papers is Epson Hot Press Natural.

    Many thanks !!
    Last edited by Kenneth Lee; February 26th, 2017 at 02:51 PM.

  6. #16
    Use the UltraHD-MK Master curve that is already installed for your printer. Print the target with that.

    best,
    Walker

  7. #17
    Junior Member
    Join Date
    Jul 2016
    Location
    Massachusetts USA
    Posts
    21
    Quote Originally Posted by walkerblackwell View Post
    Use the UltraHD-MK Master curve that is already installed for your printer. Print the target with that.
    I don't see that curve. I didn't re-install the printer from the Community Edition. What I have is from when I purchased the K7 inks originally.

    Do I need to re-install for the 3880 using the setup found in the Community Edition ?

Page 2 of 2 FirstFirst 12

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •