Piezography Workshops at Cone Editions Press!
Results 1 to 5 of 5

Thread: Trying to keep my 9800 running...

  1. #1

    Trying to keep my 9800 running...

    Hello,
    I've been running Cone inks in my 9800 for a long time, but I've been a little lax on maintenance. Haven't ever replaced any dampers, just kept it clean and I've been lucky. Now I have a magenta ink line that is full of air bubbles, probably more air than ink, and I noticed that my Magenta cart, near the delivery end, was full of thick gooey magenta ink that had thickened.
    So I'm thinking that I should replace the dampers, wiper, capping station and flushing box. And at least replace the Magenta cart.
    Am I missing anything? Should I also do a complete piezoflush? I don't have the carts, but I have been using Piezoflush for "spot" cleaning.
    Or, should I just try to Piezoflush the Magenta channel?
    And if so, should I flush before replacing dampers, or after?
    Thanks for any advice! :-)

  2. #2
    You can probably get away with putting a new cart in there that is full of PiezoFlush and then purging the line and letting the piezoflush sit for a while (48 to 72 hrs if you have the time) this will soften the ink enough to get it pretty much totally gone.

    Use a fresh (third) cart for the new Magenta.

    At this point it would not be a bad idea to replace the damper as well if you are not daunted by this task.

    all the best,
    Walker

  3. #3
    Thank you, Walker. I've ordered a new damper from Compass Micro, and I'll order the new cart and more PF.

    Thanks very much,

    Harold

  4. #4
    Walker (not sure, this might be a Dana question), I am in the middle of replacing the pump capping station, and I just realized that the instructions say to replace the porous pad in the tray above the maintenance tank. Is this critical? I don't have a new one, but I can order one if I really need it. The one in the machine is really gunked up. ***UPDATE*** I managed to rinse the original and it will work. Next time, though, it would save me a ton of time to just have a new one:-)

    Thank you!
    Harold
    Last edited by Harold Ross; March 20th, 2017 at 04:02 PM.

  5. #5
    it's not super critical but you should replace it eventually so your vacuum pump doesn’t get totally plugged.

    best,
    Walker

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •